Description of problem:

In the Satellite 6.16 Server installation doc ([Installing Satellite Server in a connected network environment | Red Hat Product Documentation|https://docs.redhat.com/en/documentation/red_hat_satellite/6.16/html-single/installing_satellite_server_in_a_connected_network_environment/index])

Section 1.9 (https://docs.redhat.com/en/documentation/red_hat_satellite/6.16/html-single/installing_satellite_server_in_a_connected_network_environment/index#tuning-with-predefined-profiles_satellite) describes the steps necessary to configure the satellite server using predefined profiles. However, none of the commands you're instructed to issue have been installed yet.  This section should be moved after Chapter 3 (https://docs.redhat.com/en/documentation/red_hat_satellite/6.16/html-single/installing_satellite_server_in_a_connected_network_environment/index#Installing_Server_Connected_satellite) when the specified commands have been installed

How reproducible:

It's documentation so it's always there.

Is this issue a regression from an earlier version:

No, the issue exists at least as far back as 6.14.

Steps to Reproduce:

1. Open https://docs.redhat.com/en/documentation/red_hat_satellite/6.16/html-single/installing_satellite_server_in_a_connected_network_environment/index#tuning-with-predefined-profiles_satellite

2.

3.

Actual behavior:
The section is too early in the installation procedure

Expected behavior:

It should be after the corresponding commands you're instructed to run have been installed https://docs.redhat.com/en/documentation/red_hat_satellite/6.16/html-single/installing_satellite_server_in_a_connected_network_environment/index#Installing_Server_Connected_satellite

(Business Impact / Additional info:

It's confusing during the installation process.