Uploaded image for project: 'Satellite'
  1. Satellite
  2. SAT-11446

The "pulp_docker_registry_port" settings is still exposed and set to port 5000 in Satellite 6.11


    • Sprint 108, Sprint 109, Sprint 110, Sprint 111, Sprint 112, Sprint 113, Sprint 114, Sprint 115, Sprint 116, Sprint 117, Sprint 118
    • Moderate

      Description of problem:

      After the introduction of Pulp 3 in Satellite 6.10 and above, there is no crane plugin in pulp3 and hence the docker registry is also not exposed via port 5000

      However, if we are to go to Administer --> Settings --> Content, We still can see that option available and set.

      Version-Release number of selected component (if applicable):

      Satellite 6.10 and 6.11

      How reproducible:

      Steps to Reproduce:
      1. Install a Satellite 6.11
      2. Either go to Satellite UI --> Administer --> Settings --> Content and check for "Pulp Docker registry port"

      or run this command in Satellite via hammer:

      1. hammer settings info --name pulp_docker_registry_port

      Actual results:

      1. hammer settings info --name pulp_docker_registry_port
        Id: pulp_docker_registry_port
        Name: pulp_docker_registry_port
        Description: The port used by Pulp Crane to provide Docker Registries
        Category: Content
        Settings type: integer
        Value: 5000

      Expected results:

      If my assumption is correct, this setting should no longer be present or its Pulp3 alternate should be present there.

      Additional info:

      I see that in Katello itself it is still defined.


            iballou@redhat.com Ian Ballou
            satellite-focaccia-bot Focaccia Bot
            Chris Roberts Chris Roberts
            0 Vote for this issue
            0 Start watching this issue