What were you trying to do that didn't work?

Install RHEL-10.0-20241120.1 on Dell PowerEdge R6515

What is the impact of this issue to you?

Server wont boot after installation

Please provide the package NVR for which the bug is seen:

RHEL-10.0-20241120.1

How reproducible is this bug?:

Always

Steps to reproduce

1. Install RHEL-10.0-20241120.1 on Dell PowerEdge R6515 such as systems in the RDMA Cluster (rdma-qe-38, rdma-qe-39, etc.)

Expected results

To successfully install and boot the server afterwards

Actual results

After installation, system fails to boot to the installed OS as can be seen on https://beaker.engineering.redhat.com/jobs/10243458
Installation complete
[...snip...]
systemd-reboot.service

• System Reboot.
  [
  OK
  ] Reached target
  reboot.target
• System Reboot.
  [ 537.337178] systemd-shutdown[1]: Could not detach loopback /dev/loop0: Device or resource busy
  [ 537.345848] watchdog: watchdog0: watchdog did not stop!
  [ 537.404057] systemd-shutdown[1]: Unable to finalize remaining loop devices, ignoring.
  [ 538.919942] ata9: failed stop FIS RX (-16)
  [ 540.768119] reboot: Restarting system

Initializing PCIe, USB, and Video... Done
PowerEdge R6515
BIOS Version: 2.16.1
Console Redirection Enabled Requested by iDRAC

F2 = System Setup
F10 = Lifecycle Controller (Config
iDRAC, Update FW, Install OS)
F11 = Boot Manager
F12 = PXE Boot
iDRAC IPV4: 10.1.216.115 [Dedicated]
Initializing Firmware Interfaces...

Enumerating Boot options...
Enumerating Boot options... Done
Loading Lifecycle Controller Drivers...
Loading Lifecycle Controller Drivers...Done
Lifecycle Controller: Collecting System Inventory...

iDRAC IPV4: 10.1.216.115 [Dedicated]

Lifecycle Controller: Done
Booting...

Booting from Integrated RAID Controller 1: Red Hat Enterprise Linux

11/23/0024 01:14:51
PowerEdge R6515 - BIOS 2.16.1
A system restart is required. The system detected an exception during the UEFI
pre-boot environment.
-------------------------------------------------------------------------------
Type: General Protection Fault (13) Source: Software (UEFI0011) on BSP
AX=AFAFAFAFAFAFAFAF BX=000000004CF544C0 SI=000000004C3090A8 DI=AFAFAFAFAFAFAFAF
CX=000000004C3090A8 DX=0000000000000003 R8=000000004C308181 R9=00000000576B4178
10=000000004C729552 11=0000000000000092 12=0000000000000000 13=0000000061D89620
14=000000004CF53728 15=000000004CF53730 BP=00000000576B3F70 SP=00000000576B3F48
IP=000000004C729880 Flags=00210202 CurrentTPL = 04, LastEventTime 000001637EE4
LastMsg:

LBRfr0 4C7298BF Unknown(pwkhz) +0128BF
LBRto0 4C72987C Unknown(pwkhz) +01287C
-->RIP 4C729880 Unknown(pwkhz) +012880
Stack trace not available