When you use AMQP JMS client to communicate with AMQ7 broker you can specify JMS selectors and receive only messages matching a specific selector. However, when connection is routed through interconnect, selectors are ignored and the client receives even messages that do not match selector.

Reproducer:

1. configure broker to start AMQP acceptor on port 5555 (instead of default)
2. run the attached reproducer against broker (it should pass)
   • mvn clean test -DSelectorTest -Damqp.port=5555
3. now configure interconnect so router so messages are routed through the router:

   listener {
       host: 0.0.0.0
       port: amqp
       authenticatePeer: no
       saslMechanisms: ANONYMOUS
   }
   
   connector {
     name: broker
     host: localhost
     port: 5555
     role: route-container
   }
   
   
   autoLink {
     addr: test.queue
     connection: broker
     dir: out
   }
   
   autoLink {
     addr: test.queue
     connection: broker
     dir: in
   }
   
   address {
       prefix: test.queue
       waypoint: yes
   }
   
   

4. now run reproducer again but connect through the router
   • mvn clean test -DSelectorTest -Damqp.port=5672
   • Test will receive also messages which does not match the selector (and the test will fail)