Uploaded image for project: 'Ansible Automation Platform RFEs'
  1. Ansible Automation Platform RFEs
  2. AAPRFE-1972

cisco.ios.ios_l3_interfaces lacking attributes

XMLWordPrintable

    • False
    • Hide

      None

      Show
      None
    • False

      The following attributes looks missing in the module `ios_l3_interfaces` in cisco.ios collection which the makes the collection usages to be restricted. 

      it makes  not able to use the resource module for configuration compliance.

       

      vrf forwarding
      mac-address 0000.0000.0001
      ip redirects
      ip mtu 1500
      ip helper-address 
      ip unreachables
      ip proxy-arp
      standby delay minimum 30 reload 60
      standby version 2
      standby 910 ip 
      standby 910 timers 3 7
      standby 910 priority 90
      standby 910 preempt delay minimum 180
      standby 910 authentication md5 key-chain hsrp-keychain
      
      
      

       

      The attributes can be seen at Network device: 

       

      (config-if)#ip ?
      Interface IP configuration subcommands:
        access-group         Specify access control for packets
        accounting           Enable IP accounting on this interface
        address              Set the IP address of an interface
        admission            Apply Network Admission Control
        arp                  Configure ARP features
        auth-proxy           Apply authenticaton proxy
        authentication       authentication subcommands
        bandwidth-percent    Set EIGRP bandwidth limit
        bgp                  BGP interface commands
        broadcast-address    Set the broadcast address of an interface
        cef                  Cisco Express Forwarding interface commands
        cgmp                 Enable/disable CGMP
        clear-dont-fragment  Enable clear dont fragment (Currently Only SDWAN Tunnel Interface)
        dampening-change     Percent interface metric must change to cause update
        dampening-interval   Time in seconds to check interface metrics
        ddns                 Configure dynamic DNS
        dhcp                 Configure DHCP parameters for this interface
        directed-broadcast   Enable forwarding of directed broadcasts
        dns                  Configure DNS server
        flow                 NetFlow related commands
        header-compression   IPHC options
        hello-interval       Configures EIGRP-IPv4 hello interval
        helper-address       Specify a destination address for UDP broadcasts
        hold-time            Configures EIGRP-IPv4 hold time
        idle-group           Specify interesting packets for idle-timer
        igmp                 IGMP interface commands
        information-reply    Enable sending ICMP Information Reply messages
        irdp                 ICMP Router Discovery Protocol
        lisp                 Locator/ID Separation Protocol
        load-sharing         Style of load sharing
        local-proxy-arp      Enable local-proxy ARP
        mask-reply           Enable sending ICMP Mask Reply messages
        mfib                 Interface Specific MFIB Control
        mrm                  Configure IP Multicast Routing Monitor tester
        mroute-cache         Enable switching cache for incoming multicast packets
        mtu                  Set IP Maximum Transmission Unit
        multicast            IP multicast interface commands
        nat                  NAT interface commands
        network-broadcast    Accept and respond to network-prefix-directed broadcasts
        next-hop-self        Configures EIGRP-IPv4 next-hop-self
        ospf                 OSPF interface commands
        pgm                  PGM Reliable Transport Protocol
        pim                  PIM interface commands
        policy               Enable policy routing
        probe                Enable HP Probe support
        proxy-arp            Enable proxy ARP
        rarp-server          Enable RARP server for static arp entries
        redirects            Enable sending ICMP Redirect messages
        rgmp                 Enable/disable RGMP
        rip                  Router Information Protocol
        route-cache          Enable fast-switching cache for outgoing packets
        router               IP router interface commands
        rsvp                 RSVP Interface Commands
        rtp                  RTP parameters
        sap                  Session Advertisement Protocol interface commands
        sdr                  Session Directory Protocol interface commands
        security             DDN IP Security Option
        service              IP service
        split-horizon        Perform split horizon
        sticky-arp           Allow the creation of sticky ARP entries
        summary-address      Perform address summarization
        tcp                  TCP interface commands
        topology-accounting  Enable accounting for IP on all topologies of interface
        unnumbered           Enable IP processing without an explicit address
        unreachables         Enable sending ICMP Unreachable messages
        urd                  Configure URL Rendezvousing
        verify               Enable per packet validation
        vrf                  VPN Routing/Forwarding parameters on the interface
        wccp                 WCCP IPv4 interface commands
      (config-if)#standby ?
        <0-255>         group number
        authentication  Authentication
        bfd             Enable HSRP BFD
        delay           HSRP initialisation delay
        follow          Name of HSRP group to follow
        ip              Enable HSRP IPv4 and set the virtual IP address
        ipv6            Enable HSRP IPv6
        mac-address     Virtual MAC address
        mac-refresh     Refresh MAC cache on switch by periodically sending packet from virtual mac address
        name            Redundancy name string
        preempt         Overthrow lower priority Active routers
        priority        Priority level
        redirect        Configure sending of ICMP Redirect messages with an HSRP virtual IP address as the gateway IP address
        timers          Hello and hold timers
        track           Priority tracking
        use-bia         HSRP uses interface's burned in address
        version         HSRP version
      

       

       

              dmendoza@redhat.com Dafne Mendoza
              rhn-support-abhishgu Abhishek Gupta
              Votes:
              0 Vote for this issue
              Watchers:
              4 Start watching this issue

                Created:
                Updated:
                Resolved: